2011 Jeep Compass with the 2.4
So far replaced thermostats and temp sensor. both fans do not run , even with Ac on and temp setting an alert.
fuses check good, fan relays and the box are clean and filled with dielectric grease and no corrosion found.Direct power to each fan via the relay terminals makes them run.AC fan only runs on high Rad fan runs on both speedsrelays read as having power at their inputs.
My wiring does not match the wiring diagrams from alldata. where can I find a different wiring diagram that shows the correct wiring colors?Ac Fan wires are Green with red and Black with white that go to 2 different relays,Rad fan( right when facing vehicle ) has 2 purple or violet wires that go to 2 different relays
now down to assuming the trigger signals from tipm are questionable or a sensor is not sending the right info. still probing and checking to see if any relay signals change, but am now lost in the wiring
system stays cool while moving, but overheats quickly when stopped at idle
Dad in Garage going nuts APPRECIATE ANY INPUT
